|
Standard
Modular Panels 2", 3" or 4"Thick
Panels are
to have 6 mil vinyl covered hardboard factory-laminated to both
sides of structural kraft honeycomb core (minimum cell size
1"), and shall be 2", 3" or 4" thick as
specified.
Panel
Facing Options
- Vinyl
faced 1/2" or 5/8" Type X gypsum board
- 24
gauge prepainted steel - .020" or .032" prepainted
aluminum
- Fiberglass
reinforced panels (FRP)
- Forest
fiberboard (for exterior use) - Stainless steel
- Other
surfaces available upon request.
Panel
Core Options
Polystyrene
1lb. or 2lb. density - Polyurethane - Fiberglass
Glazed
Panels
- Glazed
panels shall be factory assembled with 3/16" tempered
glass.
- Standard
windows to be 44" wide x 40" high.
- Glazing
is held in place by a resilient vinyl glazing gasket allowing
for easy replacement.
- Glazed
panels are interchangeable with solid panels and door panels
of like size.
- Available
in 2-foot, 3-foot, or 4-foot widths.
Glazing
Options
- Double
glazed units - Plexiglas- Lexan - 1/4" tempered tinted
colors
- Sliding
glass - Wire reinforced - Safety laminated
Door
Panels
Doors
shall be standard 3' 0" x 6' 8" x 1 3/4"
and finished to match panels. Doors are factory pre-hung
in aluminum frames and installed in a modular 4' panel.
Doors and door frames take one pair of 4" x 4"
hinges and are shipped complete with all hardware and lockset.
Door
Options
- 6'
x 6'8" double doors - 6' x 8'0" double doors -
8' x 8' double sliding doors
- Door
closures - Kick plates - Door windows - Special locks -
Custom sizes
Aluminum
Framing
All aluminum
framing is of 6063-T6 aluminum and anodized to a clear finish
for maintenance free permanency.
Connecting
Posts
- Posts
have structural capabilities of supporting loads of up 10,000
pounds.
- Standard
posts serve as channeled raceways for electrical, telephone,
and computer wiring.
- The
unique design allows for the removal of panels without disassembly
of adjoining panels
Ceilings
- The
ceiling system includes white enameled steel T-bar grid
complete with wall angle, hanger wires, 2' x 4' mineral
fiberboard tiles, and fiberglass insulation when noted.
- The
lay-in design allows for use of recessed fluorescent lighting.
Ceilings are rated Class A noncombustible.
Roof
Deck
Galvanized
ribbed steel, 1 1/2" or 3" deep x 36" wide Nestable
panels in 22, 20, or 18 gauge depending upon span and load conditions.
Decking serves as dust cover, diaphragm and support for ceiling
and light fixtures.
Electrical
Kit
Includes
electrical raceway connection posts, outlets, switches, light
fixtures and circuit panel as noted on proposal.
Note:
Wire, run to power source, ceiling conduit, and fittings are
part of the electrical package, but are not included unless
factory and electrical installation are specified.
Factory
Standard Colors and Standard Panel Cores, Click here!
|
